The fixed-price work we do most. Pricing here is for the typical case — the cost is locked in once we have diagnosed on site and you have approved the work. Anything beyond is quoted separately. The Service-detail page goes into one of these as an example.
Cooling
~ 2h on site
When the fridge stops cooling but the lights are on. The single most common job we run.
Cooling
~ 3h on site
Leak find, repair, vacuum pull, and recharge with R600a or R134a. Full refrigerant logbook stays with you.
Cooling
~ 1h on site
Replace door gasket where the seal has gone hard, torn, or no longer magnetises. Door alignment included.
Cooling
~ 2h on site
Fridge running too cold, too warm, or cycling badly. Sensor and thermostat test, replacement on the spot.
Freezer
~ 3h on site
Freezer iced up, fridge warming up. Defrost heater test, sensor swap, full cycle verification on the bench.
Freezer
~ 4h workshop
When the compressor itself has failed. Workshop job — we collect the unit, swap on the bench, return next day.
Freezer
~ 1.5h on site
Error code on the display, lights flashing, no clear pattern. Diagnostic in-place, PCB swap if needed.
Commercial
By appointment
Cold prep tables, under-counter freezers, display fridges. Same-day priority for service-contract customers.
Commercial
By appointment
Walk-in chillers and freezers — restaurants, butchers, small grocers. We service the condenser and refrigerant circuit.
Not sure which service you need? Describe the fault and we will recommend one before the visit.